Filter
Top Products
3
8
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) screws from each side of the dash trim
bezel and remove the bezel. Remove (4)
screws securing the upper radio dummy
cover to the bezel and remove.
1
TOYOTA Corolla (sport coupe/liftback) 1982-83
2
Slide Mounting Tabs #3 into slots "B" on
Bracket Set #1. The Mounting Tabs,
Brackets and Bracket slots can be identified
by the stamped letter on each component.
Skip to the Installation Instructions for ALL
VEHICLES on Page #10.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the ashtray and (3) screws from the ashtray
bracket. Remove (1) screw from each side
of the dash console and unclip the dash trim
bezel. Remove the screws securing the
factory head unit and disconnect the wiring.
1
TOYOTA Pickup 1984-88 / 4Runner 1984-88
2
Slide Mounting Tabs #3 into slots "J" and
"I" on Bracket Set #1. The Mounting Tabs,
Brackets and Bracket slots can be identified
by the stamped letter on each component.
Skip to the Installation Instructions for ALL
VEHICLES on Page #10.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(3) screws and (1) bolt securing the driver's
side speaker panel and remove the panel.
Remove (1) screw from the left side of the
housing and unsnap the ignition cover.
Remove the glove compartment assembly
by removing (1) 10mm bolt from the bottom
of the speaker panel and (3) screws from the
right side of the housing. Remove the
remaining (3) screws securing the radio trim
bezel. Remove the screws securing the
factory head unit and disconnect the wiring.
1
TOYOTA Pickup (single DIN) 1989-91
2
Slide Mounting Tabs #3 into slots "D" on
Bracket Set #12. The Mounting Tabs,
Brackets and Bracket slots can be identified
by the stamped letter on each component.
Skip to the Installation Instructions for ALL
VEHICLES on Page #10.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Pry up
on the gear shifter trim panel and remove the
panel. Remove (2) screws exposed on the
bottom edge of the radio trim bezel. Unclip
the bezel, and disconnect the ashtray and
cigarette lighter wiring. Remove the screws
securing the factory head unit and
disconnect the wiring.
1
TOYOTA Celica 1990-93
2
Slide Mounting Tabs #3 into slots "A" on
Bracket Set #1. The Mounting Tabs,
Brackets and Bracket slots can be identified
by the stamped letter on each component.
Skip to the Installation Instructions for ALL
VEHICLES on Page #10.
"A"
"B"
"B"
"J"
"I"
"D"