Filter
Top Products
7
4
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(1) screw to the right of the ignition switch.
Remove (1) screw above the left speaker.
Unclip the dash trim bezel (some force may
be required). Remove the screws securing
the factory head unit and disconnect the
wiring.
1
TOYOTA Corolla (sed/wag-lower dash) 1988-93
2
Slide Mounting Tabs #3 into slots "F" on
Bracket Set #2. The Mounting Tabs,
Brackets and Bracket slots can be identified
by the stamped letter on each component.
Skip to the Installation Instructions for ALL
VEHICLES on Page #10.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) Phillips screws above the climate
controls. Unclip the lower edge of the radio
trim bezel and remove. Remove the screws
securing the factory head unit and
disconnect the wiring.
1
TOYOTA MR2 1985-86
2
Slide Mounting Tabs #3 into slots "C" on
Bracket Set #12. The Mounting Tabs,
Brackets and Bracket slots can be identified
by the stamped letter on each component.
Skip to the Installation Instructions for ALL
VEHICLES on Page #10.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) screws from the top of the dash trim bezel
and remove the bezel. Remove (4) screws
from the factory head unit (or coin tray
dummy panel) and disconnect the wiring.
1
TOYOTA MR2 1987-90
2
Slide Mounting Tabs #3 into slots "I" on
Bracket Set #12. The Mounting Tabs,
Brackets and Bracket slots can be identified
by the stamped letter on each component.
Skip to the Installation Instructions for ALL
VEHICLES on Page #10.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) Phillips screws from each side of the
radio trim bezel. Remove the bezel.
Remove (4) screws securing the factory
head unit and disconnect the wiring.
1
TOYOTA Corolla 1984-87
2
2DR/3DR MODELS: Slide Mounting Tabs
#3 into slots "G" on Bracket Set #1. (see Fig.
A).
4DR/5DR MODELS: Slide Mounting Tabs
#3 into slots "F" on Bracket Set #1. (see Fig.
B).
The Mounting Tabs, Brackets and Bracket
slots can be identified by the stamped letter
on each component. Skip to the Installation
Instructions for ALL VEHICLES on Page #10.
"C"
"C"
"I"
"I"
Fig. A
Fig. B
"F"
"F"
"F"
"F"
"G"
"G"