Filter
Top Products
4
Figure 5: OEM638 Connectors and Indicators
SETTING UP AN OEM6 FAMILY CARD
Complete the following steps below to connect and power the OEM6 family card.
1. Install the OEM6 family card and the wiring harness in a secure enclosure to reduce environmental
exposure, RF interference, and protect against ESD.
Refer to OEM6 Family Installation and Operation User Manual (OM-20000128)
for installation instructions and technical specifications for the OEM6 family
cards.
NovAtel recommends tying floating input lines to ground.
When installing cards, ensure all standoffs are properly installed and the mounting
location is level. The amount of board deflection (bow and twist) must not exceed
0.75%. For example, on the OEM615 which is 71 mm long and 46 mm wide, the
deflection along the length must not exceed 0.53 mm and the deflection along the
width must not exceed 0.34 mm.
TOP VIEW
BOTTOM VIEW
P4001 power, data
and signaling
J3201 Ethernet
connector
J201 RF signal IN/
LNA power OUT
J302 External
Oscillator
LED Status
Indicator
J4101 expansion
header