Filter
Top Products
3
1. Recording Copyright—Unless it's for personal use only, record-
ing copyrighted material is illegal without the permission of the
copyright holder.
2. AC Fuse—The AC fuse inside the unit is not user-serviceable. If
you cannot turn on the unit, contact your Onkyo dealer.
3. Care—Occasionally you should dust the unit all over with a soft
cloth. For stubborn stains, use a soft cloth dampened with a weak
solution of mild detergent and water. Dry the unit immediately
afterwards with a clean cloth. Don't use abrasive cloths, thinners,
alcohol, or other chemical solvents, because they may damage
the finish or remove the panel lettering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
AC outlet voltages vary from country to country. Make sure that
the voltage in your area meets the voltage requirements printed on
the unit's rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).
Setting the STANDBY/ON switch to STANDBY does not fully
shutdown the unit. If you do not intend to use the unit for an
extended period, remove the power cord from the AC outlet.
5. Never Touch this Unit with Wet Hands—Never handle this unit
or its power cord while your hands are wet or damp. If water or
any other liquid gets inside this unit, have it checked by your
Onkyo dealer.
6. Handling Notes
• If you need to transport this unit, use the original packaging
to pack it how it was when you originally bought it.
• Do not leave rubber or plastic items on this unit for a long
time, because they may leave marks on the case.
• This unit's top and rear panels may get warm after prolonged
use. This is normal.
• If you do not use this unit for a long time, it may not work
properly the next time you turn it on, so be sure to use it
occasionally.
• When you’ve finished using this unit, remove all discs and
turn off the power.
7. Installing this Unit
• Install this unit in a well-ventilated location.
• Ensure that there’s adequate ventilation all around this unit,
especially if it’s installed in an audio rack. If the ventilation
is inadequate, the unit may overheat, leading to malfunc-
tion.
• Do not expose this unit to direct sunlight or heat sources,
because its internal temperature may rise, shortening the life
of the optical pickup.
• Avoid damp and dusty places, and places subject to vibra-
tions from loudspeakers. Never put the unit on top of, or
directly above a loudspeaker.
• Install this unit horizontally. Never use it on its side or on a
sloping surface, because it may cause a malfunction.
• If you install this unit near a TV, radio, or VCR, the picture
and sound quality may be affected. If this occurs, move this
unit away from the TV, radio, or VCR.
Precautions
Declaration of Conformity
We,
ONKYO EUROPE
ELECTRONICS GmbH
LIEGNITZERSTRASSE 6,
82194 GROEBENZELL,
GERMANY
GROEBENZELL, GERMANY
ONKYO EUROPE ELECTRONICS GmbH
I. MORI
declare in own responsibility, that the ONKYO product
described in this instruction manual is in compliance with the
corresponding technical standards such as EN60065,
EN55013, EN55020 and EN61000-3-2, -3-3.
For British models
Replacement and mounting of an AC plug on the power supply cord
of this unit should be performed only by qualified service personnel.
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the termi-
nal which is marked with the letter L or coloured red.
IMPORTANT
The plug is fitted with an appropriate fuse. If the fuse needs to be
replaced, the replacement fuse must approved by ASTA or BSI to
BS1362 and have the same ampere rating as that indicated on the
plug. Check for the ASTA mark or the BSI mark on the body of the
fuse.
If the power cord's plug is not suitable for your socket outlets, cut if
off and fit a suitable plug. Fit a suitable fuse in the plug.
For European Models
8. Moisture Condensation
Moisture condensation may damage this unit.
Read the following carefully:
Moisture may condense on the lens of the optical pickup, one of
the most important parts inside this unit.
• Moisture condensation can occur in the following situations:
–The unit is moved from a cold place to a warm place.
–A heater is turned on, or cold air from an air conditioner is
hitting the unit.
– In the summer, when this unit is moved from an air condi-
tioned room to a hot and humid place.
– The unit is used in a humid place.
• Do not use this unit when there’s the possibility of moisture
condensation occurring. Doing so may damage your discs
and certain parts inside this unit.
If condensation does occur, remove all discs and leave this unit
turned on for two to three hours. By this time, the unit will have
warmed up and any condensation will have evaporated.