Filter
Top Products
En-31
Using the Timer
The CD receiver has a programmable timer for
automated playback, and a sleep timer for turning the
CD receiver off after a specified period.
You can also use the alarm playback function of your
iPod/iPhone to initiate timer playback on the CD
receiver.
The timer can be used to start FM, CD, iPod/USB, or
LINE playback at a specified time. You could, for
example, use a timer to turn on the CD receiver every
morning, just like a radio alarm clock.
Note:
• If iPod is selected as the input source for the timer
settings, USB will play if only a USB flash drive is
connected, and iPod/iPhone will play if an iPod/
iPhone is connected.
Notes:
• You must set the clock before you can program the
timer.
• If you don’t operate any buttons for 5 seconds while
programming a timer, the procedure will be cancelled
and the previous display will reappear.
• When the CD receiver is turned on by the timer,
playback will begin with the most recently received
station in the case of FM, the first song in the case of
a CD or iPod (USB), and the current state of the
connected device in the case of LINE.
• Only one timer can be set.
1
Prepare the source that you want the timer
to play.
If you want FM to play, tune to the station you
want to hear.
If you want a CD to play, insert the disc.
For an iPod/iPhone, place it in the dock. If you’re
using a USB flash drive rather than an iPod/iPhone,
disconnect the iPod/iPhone from the iPod dock
(see page 29).
If you want to play a device connected to LINE,
make settings on the connected device so that it
will start playing when the timer operates.
2
Press the [TIMER] button repeatedly until
“Timer XX” appears.
“XX” indicates the source that was last selected for
timer playback.
3
Use the arrow []/[] buttons to select the
source, and then press [ENTER].
You can select the following sources:
FM, CD, iPod (USB), LINE.
In the display, “TIMER” and a number indication
will blink according to the input source you’ve
selected.
The number will be “1” for FM, “2” for CD, “3”
for iPod (USB), and “4” for LINE.
4
Use the arrow []/[] buttons to specify the
“hour” at which you want the timer to play,
and then press [ENTER].
5
Use the arrow []/[] buttons to specify the
“minute” at which you want to timer to play,
and then press [ENTER].
6
Use the arrow []/[] buttons to select
“Timer On,” and then press the [ENTER]
button.
When a timer is turned on, its TIMER and number
appears on the display.
If there is no operation for several seconds, the
setting will be made with the currently-shown
content.
The display will return to its previous state except
for “TIMER” and the number of the selected input
source; the timer is now set.
7
Press the [ ON/STANDBY] button or the
remote controller’s [] button to set the CD
receiver to Standby.
Programming the Timer
M
F
/
H
ENTER
TIMER
DISPLAY
Tim„„er„„ F„„M„„ „„
Tim„„er„„--„„:„„--„„
Tim„„er„„ 6„„:„„00„„