Filter
Top Products
25
Playing a USB Flash
Drive
1
Press the [iPod] button to select “iPod”.
Alternatively, you can use the CD receiver’s
[INPUT] button.
2
Press and hold the [MODE] button until
“USB” appears (about 3 seconds).
3
Insert a USB flash drive in the USB port.
4
To start playback, press the [ / ] button.
Selecting folders and files, and using the random
play and repeat play functions, are the same as
when playing back MP3 files from a CD (see
page 19).
Note:
• Do not connect your USB flash drive via a USB hub.
• When connecting or disconnecting a USB flash drive,
use your hand to support the CD receiver so that it
does not move.
• For details on the usable formats for a USB flash
drive, refer to page 12 “Playback from USB Flash
Drives”.
• If your iPod/iPhone/iPad is used, switch the
connection mode to iPod (see page 21).
• Do not connect the CD receiver’s USB port to a USB
port on your computer. Music on your computer
cannot be played through the CD receiver in this way.
Setting the Clock
1
Press the [TIMER] button repeatedly until
“Clock” appears.
2
Press [ENTER].
3
Use the arrow [ ]/[ ] buttons to enter the
current hour.
When the CD receiver is shipped from the factory,
the time display format is set to 24-hour time. Set
the current hour as it would appear in 24-hour time.
If you want to set the current hour as 12-hour time,
press the [DISPLAY] button.
4
Press [ENTER].
5
Use the arrow [ ]/[ ] buttons to enter the
current minute.
6
Press [ENTER].
The clock is set and the second dot starts flashing.
Displaying the Time
To display the time, press the remote controller’s
[CLOCK CALL] button. Press the button again or
perform another operation to cancel the time display.
If the CD receiver is on Standby, the time will be
displayed for about 8 seconds.
While the CD receiver is on, the time are displayed
continuously.
Change the time format
To change the time format between 12-hour and 24-hour,
press the [DISPLAY] button.
This section describes the procedure for using the
remote controller, unless otherwise specified.
USB flash drive
This section describes the procedure for using the
remote controller, unless otherwise specified.
Setting the Clock