Filter
Top Products
4-CHANNEL AMPLIFIER INPUT CONFIGURATIONS
The 2-channel input / 4-channel input switch routes RCA input from the front RCA inputs to the rear section of the amplifier. This
allows the XTREME 4-channel amplifier to utilize a single set of RCAs to feed signal to both the front and rear channels of the
amplifier.
When the switch is in engaged, signal from the front RCA input is routed to the rear RCA inputs.
NOTE: In this configuration, the rear RCA inputs can be routed to another amplifier. The signal leaving the amplifier is a copy of
the incoming signal.
When the switch is disengaged, front and rear RCA inputs are independent. This allows a source unit with an internal fader to
fade between the front and rear outputs.
OUTPUT CONFIGURATIONS
Three position switches determine output configuration for the XTREME amplifiers. Each stereo pair of channels can be configured in either stereo,
summed-bridged and bridged-mono. The switch or switches are located on he outermost edge of the amplifier.
When the switch is in the left position, the output channels are configured for stereo operation.
When the switch is in the center position, the output channels are configured for summed mono operation by
mixing the left and right input signals together.
When the switch is in the right position, the output channels are configured for a single bridged output using a
single RCA input. To determine which RCA to use, refer to the marking in parenthesis. For the front outputs, the Left
RCA input is used. For the rear outputs, the Right RCA input is used.
page 24