Filter
Top Products
M
1
2
3
4
14 15
CQ-C1110W/C1100WCQ-C1110W/C1100W
11
E
N
G
L
I
S
H
12
E
N
G
L
I
S
H
Installation (Continued)
Cautions:
• We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
• When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your
hands and fingers.
Establish the rear connection of the
unit.
After fixing Mounting Bolt t and insert the
Power Connector y, fix the rear of the unit to
the car body by either method (a) or (b) shown
on the previous page.
Insert Trim Plate u.
After installation reconnect the neg-
ative (–) battery terminal.
First complete the electrical connections, and then
check them for correctness. (➡ page 16)
Insert Mounting Collar q into the
dashboard, and bend the mounting
tabs out with a screwdriver.
The included Mounting Collar
q is designed specially for
this unit. Do not use it to
attach any other model.
y Power Connector
Engage the both sides
Mounting Springs
(C) in the mounting
holes of the Mounting
Collar q firmly.
Mounting Spring
Mounting
Hole
q Mounting
Collar
Mounting Springs (C)
Mounting Holes
t Mounting Bolt
The tabs to be bent vary depending on the
car. To securely install the unit, fully bend
a number of the tabs so that there is no
rattling.
Example:
Tab
1
2
To Remove the unit
Switch off the power of the unit.
Remove the Trim Plate u with a screw-
driver.
qInsert the Dismounting Plate i along
the grooves on both sides of the main
unit until
“
click
”
is heard.
wPull out the unit while pushing the plates
further inside.
q Press
u Trim Plate
Screwdriver
Remove the unit pulling with both hands.
q
w
e
r
w
qInsert
wPull out
i Dismounting Plate
“Click”
Insert the tab
end in the
outer groove.
Contact
Release button
qPress []. The remov-
able face plate will be
opened.
w Push the face plate to
either the right or left.
e Pull it out toward you.
Remove the Removable
Face Plate.
IMPORTANT
When this unit is installed
in dashboard, ensure that
there is sufficient air flow
around the unit to prevent
damage from overheating,
do not block any ventilation
holes on the unit.