Filter
Top Products
51
Installation
CQ-CB8901U
50
Installation
CQ-CB8901U
1
3
2
ACC
BATTERY 15A
FRONT SP
REAR SP
Power Lead
(
ACC or IGN
)
To ACC power, +12 V DC.
Ground Lead To a clean, bare metallic part of the car chassis.
Battery Lead To the car battery, continuous +12 V DC.
Fuse (15 A) Refer fuse replacement to your nearest authorized Panasonic
Servicenter. Do not try fuse replacement by yourself.
(Red)
(Black)
(Yellow)
(Blue w/white stripe)
(Blue)
External Amplifier Control Power Lead To an external amplifier.
(Max. 100 mA)
(R) (Red)
(L) (White)
Pre-out Cord (Rear)
Pre-out Cord
(
Front
)
AUX1-IN
CH/AUX2-IN
S･W-OUT
PRE-OUT REAR
PRE-OUT FRONT
Antenna
AUX Input Connector
CD Changer/AUX/XM receiver Input Connector
The RCA cord of a CD changer/AUX/XM receiver
should be connected.
Subwoofer Output Connector
The RCA cord of a external power amplifer should be connected.
Motor Antenna Relay Control Lead To Motor Antenna. (Max. 100 mA)
(This lead is not intended for use with a switch actuated power antenna)
Front Left + (White)
Front Left – (White w/black stripe)
Rear Right + (Violet)
Rear Ri
g
ht –
(
Violet w/black stri
p
e
)
Front Right + (Gray)
Front Right – (Gray w/black stripe)
Rear Left + (Green)
Rear Left – (Green w/black stripe)
Speaker lead
(R) (Red)
(L) (White)
(R) (Red)
(L) (White)
(R) (Red)
(L) (White)
Not used (Brown w/white stripe)
(Red)
(White)
Cautions
¡This unit is designed for use in a car having a 12 V negative ground battery system.
¡To prevent damage to the unit, be sure to follow the connection diagram below.
¡Strip about 5 mm of the lead ends for connection.
¡Do not insert the power connector into the unit until the wiring is completed.
¡Be sure to insulate any exposed wires to prevent short circuiting with the car chassis. Bundle all
cables, and prevent cable terminals from touching any metal parts.
¡Remember, if your car has drive computer or a navigation computer, the data of its memory may be
erased when the battery terminals are disconnected.
Electrical Connections