Filter
Top Products
CQ-R221U
16
E
N
G
L
I
S
H
7
Cassette Tape Player Basics
continued
TPS Operation (Tape Program
Search)
ቢ
Press [3] (TPS) to activate the tape program search mode.
ባ
From the current selection, decide which program you want to
select. Now, press [
̈̈
] several times forward (up to 9
programs) or press [
̇̇
] several times backward (up to 8 ) to
select the corresponding program number.
EX1. To select the current program
again press [3] (TPS), and press
[
̇̇
] once.
EX2. To select the 1st program
backward of the current selection,
press [3] (TPS) once, and press
[
̇̇
] two times.
EX3. To select the next program, press
[3] (TPS) and press [
̈̈
] once.
EX4. To select the 3rd program forward
of the current selection, press [3]
(TPS) once, and press [
̈̈
]
three times.
ቤ
To turn it off, press [3] (TPS) again.
(Rewind:)
80
c
(Fast forward:)
19
c
Note:
The TPS mode may not work correctly in the following cases. This, however, does not mean that
the unit is defective.
●
There is an interval less than 4 seconds or having a high level of noise or hum between
programs.
●
There is particularly low-level passage during the program.
Notes:
●
To maintain your cassette player in top condition, avoid using tapes that are longer than 90
minutes (C-90).
●
If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a
finger or the like, the cassette may not be properly reproduced. In such a case, eject the
cassette, make the tape tight, then insert it back into the deck.
Notes on Cassette Tapes
Pencil
Do not touch
or pull out
the tape.
Tape Slack:
Use a pencil or similar object to take up the slack
as shown. If a loose tape is used, this may result
in the tape becoming tangled in the rotating
parts of the unit.
S
•H
D
B
S
•H
D
B
d
or
ቢ
ቤ
ባ
ባ