Filter
Top Products
15
Basic Controls
POWER button
The Plasma Display must fi rst be plugged
into the wall outlet and turned on at the
power switch (see page 12).
Press this button to turn the Plasma
Display On, from Standby mode. Press
it again to turn the Plasma Display Off to
Standby mode.
ACTION button
Press to make selections.
ASPECT button
Press to adjust the aspect.
(see page 16)
POS. /SIZE button
(see page 21)
PICTURE button
(see page 22)
Sound mute On / Off
Press this button to mute the sound.
Press again to reactivate sound.
Sound is also reactivated when power is
turned off or volume level is changed.
N button
(see page 21, 22, 23, 24)
POSITION buttons
INPUT button
Press to select INPUT1, INPUT2, INPUT3
and PC input SLOTS sequentially. (see
page 13)
When a dual input terminal board is
attached, A or B is displayed depending
on the selected input signal. (Ex.
INPUT1A, INPUT1B)
MULTI Window buttons
(see page 17)
Digital Zoom (see page 19)
Remote Control Transmitter
SET UP button (see page 20)
SOUND button (see page 24)
Volume Adjustment
Press the Volume Up “+” or Down “–”
button to increase or decrease the
sound volume level.
R button (see page 20)
Press the R button to return to
previous menu screen.
OFF TIMER button
The Plasma Display can be preset
to switch to stand-by after a fi xed
period. The setting changes to 30
minutes, 60 minutes, 90 minutes
and 0 minutes (off timer cancelled)
each time the button is pressed.
30 60
0
90
When three minutes remain, “OFF
TIMER 3” will fl ash.
The off timer is cancelled if a
power interruption occurs.
SURROUND button
The surround setting switches on and off each time
the SURROUND button is pressed.
The benefi ts of surround sound are enormous. You
can be completely enveloped in sound; just as if you
were at a concert hall or cinema.
Note:
The surround settings are memorized separately
for each AUDIO MENU (STANDARD, DYNAMIC,
CLEAR).
ON
SURROUND
ON OFF
The remote control is not
included with this set. Available
for purchase separately.
Object model : N2QAYB000178
OFF TIMER 90
1
2
3
4
PC
4:3
10:00
RECALL button
Press the “RECALL” button to display
the current system status.
1
Input label
2
Aspect mode (see page 16)
3
Off timer
The off timer indicator is displayed only
when the off timer has been set.
4
Clock display (see page 37)