Filter
Top Products
11
X260.5 Owners Manual
Water and moisture: Electrical devices should not be used near water (
as per example, near a bathtub, washbasin, kitchen sink, laundry tub, wet
basement or swimming pool ). Care should be taken such that objects
do not have the opportunity to fall, and that liquid is never spilled onto or
into the device enclosure through openings.
Power Sources: An electrical device must be connected to a mains
power source in strict accordance with the supplied product owner’s
manual. Please verify that the AC mains voltage specified in the product
manual matches those requirements indicated on the unit and the AC
voltage provided to your location by the power company.
Grounding: Adequate precautions should be taken so that the
grounding provisions built into an electrical product are never defeated.
Power Cords: Pass Laboratories provides a power supply cord that
meets all legislated requirements for the market in which the product was
originally sold. If you choose to substitute an after-market product we
urge you to choose one that is fully safety rated by the necessary local
authority.
Power Cord Protection: Power supply cords should be routed so that
they are not likely to be walked on, abraded, or pinched by items placed
on or against them, paying particular attention to cords where they enter
plugs or exit from a device. Never under any circumstance insert a cut or
damaged power cord into a mains power socket.
Power and Signal: Cables should never be connected / disconnected
with equipment powered up. Failure to heed this warning may damage or
destroy equipment.
Ventilation: Power-amplifiers run hot, but you should be able to place
your hands on them without discomfort. You must allow for this heat
in installation, by providing for free air circulation around the product.
Electronics should not be subjected to sources of excessive radiant heat.
Excessive heat can shorten the life of the product and may cause the
electronics to self-protect and shut down.
Servicing: To reduce the risk of fire, electrical shock or other injuries,
the user should not attempt to service the device beyond that which
is described in the operating instructions. All other servicing must be
referred to qualified service personnel.
For Units With Externally Accessible Fuse Receptacle: Unplug
the device from all sources of power before changing or inspecting any
fuse. Replace fuse with one of same physical size, type and rating as that
specified by the manufacturer for that product.
For your protection please
read the following: