Filter
Top Products
7
X260.5 Owners Manual
fier. The positive of the 12 volts DC goes to the red connector. This
connection has an actual operating range of about 9 volts to 15 volts
at a current draw of approximately 5.0mA. This switching will over-
ride the front panel button, so if you want the front panel button to
operate, leave the rear connection open.
So much for the most essential information.
The Pass Laboratories™ X260.5 is optimized for loads nominally rated
at 4 ohms and above. You can run the amplifiers into a lower nominal
impedance without difficulty, and we are not aware of a speaker on the
market that presents unusual difficulty with these amplifiers.
The X.5 series amplifiers do not care particularly about the reactivity of
the load. Reactive loads typically will have slightly less distortion at a
given voltage/current level than resistive loads, but will make the ampli-
fier run a little hotter. The X.5 circuit was designed to be quite happy
driving electrostatic and other difficult speakers.
When driving transformer-coupled loads directly, as in some electrostat-
ic and ribbon designs, some attention must be paid to the DC character
of the situation. If the transformer primary is being driven raw with no
protection from DC and your source has DC voltage, or in cases where
the small offset of the power amplifier is still too much, you may cre-
ate distortion in the transformer and get less than optimal performance
from it. Generally this is not the case with transformer-coupled loud-
speakers, but it does occasionally surface. In these cases, take special
care that the source does not contain a differential DC component, and
confirm the differential DC offset of the pre-amplifier is sufficiently
low. This differential voltage is easily adjusted by a qualified technician
armed with the appropriate service documents.
We have a general recommendation about interconnects, which is that
they should cost less than the amplifier, and be flexible enough to work
with. We have tried a lot of products and most of them work well, but
as a practical matter we cannot make blanket recommendations.
The amplifier is not sensitive to source interconnects or ground loops.
It is also not sensitive to radio frequency pickup, which allows some flex-
ibility in choosing source interconnects without shields, though shields
are always in good taste.
We prefer speaker cables that are thick and short. Silver and copper are
the preferred metals. If you find any cable made of gold, please gift us
a couple hundred meters.
Speaker Interface
Interconnects and Speaker
Cables