Filter
Top Products
UNDERSTANDING THE LED INDICATOR
See separate table.
FIRST TIME SETUP
The WFS 3.70 Wireless AirPlay
®
speaker system needs to be connected to the
same wireless network as the Mac, PC or iOS device.
Note 1. The WFS 3.70 speaker system supports DHCP and will automatically
re-connect to the wireless network after the first-time setup.
Note 2. Moving the WFS 3.70 speaker system to a new wireless network or
changing the wireless network settings requires a new setup.
AUTOMATIC SETUP USING WI-FI PROTECTED SETUP, WPS
If the wireless router supports WPS the setup is automatic.
A. Switch on the WFS 3.70 speaker system.
B. The LED flashes green quickly for about 30 seconds while booting up.
C. The LED flashes green slowly to indicate that the WFS 3.70 speaker system is
ready for setup.
D. Press the “WPS” button on the wireless router.
E. Press the “Setup” button on the right side speaker’s rear panel for one
second.
F. The LED flashes green/amber slowly to indicate that the WFS 3.70 speaker
system enters WPS mode.
G. The WFS 3.70 speaker system automatically connects to the wireless
network. If the wireless signal isn’t strong enough, the WFS 3.70 speaker
system will keep trying to connect while the LED flashes green/amber slowly.
H. The LED turns solid green followed by a beep to indicate that the WFS 3.70
speaker system is connected to the wireless network.
I. If you wish to change the name of the WFS 3.70 speaker system you open its
IP address in a browser, then type in your selected name in the “AirPlay device
name” box and press “Update”. Please see the router manual for instructions
on how to retrieve IP addresses. For AirPort Express open AirPort Utility >
Select the AirPort Express > Advanced > Logs and Statistics > DHCP Clients
and locate the WFS 3.70 speaker system in the list of clients.
Note 1. WPS requires an encrypted network.
Note 2. If the automatic setup fails, please run the manual setup instead.