Filter
Top Products
User Manual BDL3231/BDL4231
RETURN TO THE CONTENT
S
Tilt/Stability - All televisions must comply with
recommended international global safety standards
for tilt and stability properties of its cabinet design.
• Do not compromise these design standards by
applying excessive pull force to the front, or top,
of the cabinet which could ultimately overturn
the product.
• Also, do not endanger yourself, or children, by
placing electronic equipment/toys on the top of
the cabinet. Such items could unsuspectingly fall
from the top of the set and cause product
damage and/or personal injury.
Wall or Ceiling Mounting - The appliance
should be mounted to a wall or ceiling only as
recommended by the manufacturer.
Power Lines - An outdoor antenna should be
located away from power lines.
Object and Liquid Entry - Care should be
taken so that objects do not fall and liquids are not
spilled into the enclosure through openings.
Battery Usage CAUTION - To prevent battery
leakage that may result in bodily injury, property
damage, or damage to the unit:
• Install all batteries correctly, with + and - aligned
as marked on the unit.
• Do not mix batteries (old and new or carbon and
alkaline, etc.).
• Remove batteries when the unit is not used for a
long time.
17.
18.
19.
20.
21.
For ventilation, leave at least 4” to 6” free all around
the monitor. Do not place the monitor on a carpet.
The equipment shall not be exposed to dripping or
splashing.
The equipment shall not be exposed to rain or
moisture and objects filled with liquids, such as
vases, shall be placed on the apparatus.
The apparatus must be connected to a mains socket
outlet with a protected earthed connection.
The appliance coupler is used as the disconnect
device of this apparatus, the disconnect device shall
remain readily operable.
Outdoor Antenna Grounding - If an outside
antenna is connected to the receiver, be sure the
antenna system is grounded so as to provide some
protection against voltage surges and built up static
charges.
Section 810 of the National Electric Code, ANSI/
NFPA No. 70-1984, provides information with
respect to proper grounding of the mast and
supporting structure, grounding of the lead-in wire
to an antenna discharge unit, size of grounding
connectors, location of antenna-discharge unit,
connection to grounding electrodes, and
requirements for the grounding electrode.
See Figure below.
22.
23.
24.
25.
26.
27.
Note to the CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines
for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
Example of Antenna Grounding as per NEC -
National Electric Code