Filter
Top Products
5
2. Setting up the monitor
Insert your SD card
1. Disconnect the power cord.
2. Insert your SDHC card to the card slot.
Connect for VGA/HDMI input
1. Connect with VGA or HDMI cable from
your PC or AV device to SMART All-in-
One.
2. Connect power cord to SMART All-in-One
rmly and press the power button on.
3. The SMART All-in-One turns on and
enters the previous source input selected.
4. Press the input button to select VGA or
HDMI source.
Connect to either WiFi or Ethernet for
SMART All-in-One input
1. Connect RJ-45 LAN cable to your LAN
port for wired connection.
2. Connect power cord to SMART All-in-One
rmly and press the power button on.
3. The SMART All-in-One turns on and
enters the previous source input. selected
4. Press the input button to select
Android source.
5. Turn on the WiFi or Ethernet function in
the Android system settings screen.
Adjusting viewing angle
For optimal viewing, it is recommended to look
at the full face of the SMART All-in-One, then
adjust the SMART All-in-One’s angle to your
own preference.
The SMART All-in-One's tilted angle is
adjustable from 12° to 54°.
Note
• Do not touch the LCD screen when you
adjust the angle. It may cause damage or
break the LCD screen.
• Careful attention is required not to catch
your fingers or hands when you adjust the
angle.
• It is recommended to stabilize with a fixed
point in order to lock the stand if the tilted
angle is equal to or over 12°.
• Do not adjust the tilt angle less than 12°.
The monitor may fall caused by instability.
• For displays with glossy bezels the user
should consider the placement of the
display as the bezel may cause disturbing
reflections from surrounding light and
bright surfaces.