Filter
Top Products
INSTALLATION MANUAL
MANUEL D’INSTALLATION
<KYMFF/01D00000>
AVX-P7300DVD
Printed in Japan
Imprimé au Japon
<CRD3479-A> UC
Connecting the Units <ENGLISH>
Note:
• This unit is for vehicles with a 12-volt battery and
negative grounding. Before installing it in a recre-
ational vehicle, truck, or bus, check the battery
voltage.
• To avoid shorts in the electrical system, be sure to
disconnect the ≠ battery cable before beginning
installation.
• Refer to the owner’s manual for details on
connecting the power amp and other units, then
make connections correctly.
• Secure the wiring with cable clamps or adhesive
tape. To protect the wiring, wrap adhesive tape
around them where they lie against metal parts.
• Route and secure all wiring so it cannot touch any
moving parts, such as the gear shift, handbrake and
seat rails. Do not route wiring in places that get
hot, such as near the heater outlet. If the insulation
of the wiring melts or gets torn, there is a danger of
the wiring short-circuiting to the vehicle body.
• Don’t pass the yellow lead through a hole into the
engine compartment to connect to the battery. This
will damage the lead insulation and cause a very
dangerous short.
• Do not shorten any leads. If you do, the protection
circuit may fail to work when it should.
• Never feed power to other equipment by cutting
the insulation of the power supply lead of the unit
and tapping into the lead. The current capacity of
the lead will be exceeded, causing overheating.
• When replacing fuse, be sure to use only fuse of
the rating prescribed on the fuse holder.
• If the RCA pin jack on the unit will not be used, do
not remove the caps attached to the end of the con-
nector.
• To prevent incorrect connection, the input side of
the IP-BUS connector is blue, and the output side
is black. Connect the connectors of the same
colors correctly.
• If this unit is installed in a vehicle that does not
have an ACC (accessory) position on the ignition
switch, the red lead of the unit should be connected
to a terminal coupled with ignition switch ON/OFF
operations. If this is not done, the vehicle battery
may be drained when you are away from the vehi-
cle for several hours. (Fig.1)
Fig. 1
No ACC positionACC position
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
This product conforms to CEMA cord colors.
Le code de couleur des câbles utilisé pour ce produit est
conforme à CEMA.
• Cords for this product and those for other products
may be different colors even if they have the same
function. When connecting this product to another
product, refer to the supplied Installation manuals
of both products and connect cords that have the
same function.
Multi-CD player
(sold separately)
Hide-away TV Tuner
(e.g. GEX-P7000TV)
(sold separately)
Multi-Channel AV
Master Unit (e.g. AVM-P9000R)
(sold separately)
Green
Gray
Green
RCAcable (supplied)
RCAcable
(sold separately)
Blue
Yellow
IP-BUS cable (supplied with the
Multi-ChannelAV Master Unit)
Optical cable
(supplied with the Multi-
ChannelAV Master Unit)
6m
20 pin cable
(supplied with the TV tuner)
IP-BUS cable
(supplied with the TV tuner)
Blue
Blue
Black
Red
Green
20 pin cable
(supplied)
FM MODULATOR
IP-BUS MAIN UNIT
IP-BUS AV MASTER
Blue
Red
Connection box
(supplied with the DVD
Navigation Unit)
RCAcables (sold separately)
Green
Red
To audio outputs
To video output
RGB cable
(supplied with the Multi-
ChannelAV Master Unit)
Red
Yellow
White (Left)
Red (Right)
AV cable
(supplied with the
Multi-ChannelAV
Master Unit)
40 cm
40 cm
3m
Yellow
(AVM OUTPUT)
Not used.
Voice guidance speaker
(supplied)
DVD Navigation Unit
(e.g.AVIC-9DVD)
(sold separately)
This product
Black
3m
Yellow/black
ToYellow/black lead (GUIDE ON)
on the navigation unit.
Gray
16 cm
Blue
Fig. 2
When Connecting the Multi-Channel AV Master Unit