Filter
Top Products
Installation <ENGLISH>
Installing the Voice Guidance Speaker
Precaution:
• Do not install on the dashboard where it may be subjected to direct sunlight. High temperatures
may result in damage to the unit.
• Install within the transmission range of the remote control signal.
Stick the supplied velcro tapes to both the back of the voice guidance speaker and center
console, and attach them.
Fig. 14
Velcro tape
(rough surface)
Voice guidance speaker
Velcro tape
(soft surface)
2. Fastening the unit to the factory radio mounting bracket.
(Fig. 12) (Fig. 13)
Select a position where the screw holes of the bracket and the screw holes of this product
become aligned (are fitted), and tighten the screws at 2 places on each side. Use any of
binding screws (4 × 3 mm), binding screws (5 × 6 mm) or flush surface screws (5 × 6
mm), depending on the shape of the screw holes in the bracket.
*1 Use binding screws (4 × 3 mm) only.
Fig. 12
Fig. 13
11
13
12
*
1
*
1
Screw
Dashboard or Console
Factory radio mounting bracket