Filter
Top Products
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel and
wrap any loose cables so they are notblock-
ing the vents.
5cmcm
Leave ample
space
5 cm
5 cm
DIN front/rear mount
This unit can be properly installed using either
front-mount or rear-mount installation.
Use commercially available parts when instal-
ling.
DIN Front-mount
1 Insert the mounting sleeve into the dash-
board.
For installation inshallow spaces, use the sup-
plied mounting sleeve. If there is enough space,
use the mounting sleeve that came with theve-
hicle.
2 Secure the mounting sleeve by using a
screwdriver to bend the metaltabs (90°) into
place.
1
2
1 Dashboard
2 Mounting sleeve
# Make surethat the unit isinstalled securely in
place. Anunstable installation maycause skipping
or othermalfunctions.
DIN Rear-mount
1 Determine the appropriate position
where the holes on the bracketand the side
of the unit match.
2 Tighten two screws on each side.
1
2
3
1 Screw
2 Mounting bracket
3 Dashboard or console
! Use eithertruss (5mm × 8mm) or flushsur-
face (5mm ×9mm) screws, dependingon
the bracketscrew holes.
Removing the unit
1 Remove the trim ring.
1 Trimring
2 Notched tab
! Releasing thefront panel allowseasier ac-
cess tothe trim ring.
! When reattachingthe trim ring,point the
side withthe notched tabdown.
2 Insert the supplied extraction keys into
both sides of the unit until they clickinto
place.
3 Pull the unit out of the dashboard.
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
Press thedetach button and push the front
panel upward and pull it toward you.
For details, referto Removing the front panel to
protect your unit from theft and Re-attaching the
front panel on page 5.
Securing the front panel
The front panel can be secured withthe sup-
plied screw.
1
1 Screw
English
Installation
15
Section
Installation
En
03