Filter
Top Products
Bluetooth Telephone
Important
! Since this unit is on standby to connect with
your cellular phone via Bluetooth wireless
technology, using this unit without running
the engine can result in battery drainage.
! Advanced operations that require your atten-
tion such as dialing numbers on the monitor,
using phone book, etc., are prohibited while
you are driving. When you need to use these
advanced operations, stop your vehicle in a
safe place.
Setting up for hands-free phoning
Before you can use the hands-free phoning
function you must set up the unit for use with
your cellular phone. This entails establishing a
Bluetooth wireless connection between this
unit and your phone, pairing your phone with
this unit, and adjusting the volume level.
1 Connection
For detailed instructions on connecting your
phone to this unit via Bluetooth wireless tech-
nology, refer to Connecting and disconnecting
a cellular phone on the next page.
2 Pairing
Pairing is usually performed automatically
during the connection operation. You only
need to perform this operation manually when
your phone is connected temporarily for any
reason.
We recommend you pair the phone to this unit
to make best use of the technology.
To pair your temporarily connected phone,
refer to Pairing a connected cellular phone on
page 26.
3 Volume adjustment
Adjust the earpiece volume on your cellular
phone for comfort. When adjusted, the volume
level is recorded in this unit as the default set-
ting.
# Caller’s voice volume and ring volume may
vary depending on the type of cellular phone.
# If the difference between the ring volume and
caller’s voice volume is big, overall volume level
may become unstable.
# Before disconnecting the cellular phone from
this unit, make sure to adjust the volume to a
proper level. If the volume is muted (zero level) on
your cellular phone, the volume level of your cel-
lular phone remains muted even after the cellular
phone is disconnected.
Notes
! The equalizer curve for the phone source is
fixed.
! When selecting the phone source, you can
only operate FADER (balance adjustment) in
the audio menu.
! When selecting the phone source, the fader
value is set to FADER:F15 as an initial setting.
Introduction of connection and
registration
1 Press MULTI-CONTROL to display the
main menu.
2 Use MULTI-CONTROL to select
CONNECTION.
The connection menu is displayed.
Turn to change the menu option. Press to se-
lect.
# You can also select this menu by pressing and
holding PHONE/
/CONNECT on the ordinary
display.
3 Turn MULTI-CONTROL to select the
function.
PAIRED PHONE (paired phone)—
BT HANDS FREE (new phone)—SET PHONE
(phone registration)—DISCONNECT PHONE
(disconnect phone)—DELETE PHONE (delete
phone)
If the phone is not connected and not
paired
The following function can be operated.
! BT HANDS FREE (new phone)
If the phone is not connected but paired
The following functions can be operated.
! PAIRED PHONE (pair phone manually)
Operating this unit
En
23
Section
02
Operating this unit