Filter
Top Products
After connected, this unit automatically
changes to PH. BOOK DL (phone book down-
load confirmation) display.
# If the connection fails, ERROR is displayed. In
this case, check the cellular phone and try again.
4 Use MULTI-CONTROL to decide to
download the phone book from your cellu-
lar phone or not.
Push MULTI-CONTROL left or right to select
NO (No) or YES (Yes).
Press MULTI-CONTROL to decide.
When you select YES, this unit changes to
PH BOOK DOWNLOAD and the download op-
eration automatically begins. After complet-
ing, DATA DOWNLOADED is displayed.
# When you select NO, the display reverts to
normal.
Disconnecting a cellular phone
1 Display the connection menu.
Refer to Introduction of connection and regis-
tration on page 23.
2 Use MULTI-CONTROL to select
DISCONNECT PHONE.
3 Press MULTI-CONTROL to disconnect a
cellular phone from this unit.
After disconnection is completed,
DISCONNECTED is displayed.
Pairing a connected cellular phone
Pairing is usually performed automatically dur-
ing the connection operation. You only need to
perform this operation manually when your
phone is connected temporarily for any reason.
We recommend you pair the phone to this unit
to make best use of the technology.
1 Display the connection menu.
Refer to Introduction of connection and regis-
tration on page 23.
2 Use MULTI-CONTROL to select
SET PHONE.
3 Push MULTI-CONTROL up or down to
select a pairing assignment.
1 (user phone 1)—2 (user phone 2)—3 (user
phone 3)
# Push MULTI-CONTROL left or right to switch
the BD address and device name.
# If a phone is already assigned to the user
phone number, the new phone will overwrite the
old one.
# As you select each assignment, you can see
whether or not a phone is already paired. If the
assignment is empty, NO DATA is displayed.
4 Press MULTI-CONTROL to pair the cur-
rently connected phone.
When pairing is completed, COMPLETED is
displayed.
# If the pairing fails, REGISTER ERROR is dis-
played. In this case, return to step 1 and try
again.
Deleting a registered phone
1 Display the connection menu.
Refer to Introduction of connection and regis-
tration on page 23.
2 Use MULTI-CONTROL to select
DELETE PHONE.
3 Push MULTI-CONTROL up or down to
select a pairing assignment.
1 (user phone 1)—2 (user phone 2)—3 (user
phone 3)
# Push MULTI-CONTROL left to display the BD
address of the selected device.
# If the assignment is empty, NO DATA is dis-
played and operation is not possible.
4 Push MULTI-CONTROL right to select
DELETE YES.
DELETE YES is displayed. Deleting phone is
now on standby.
5 Press MULTI-CONTROL to delete the
phone.
After the phone is deleted, DELETED is dis-
played.
Operating this unit
En
26
Section
02