Filter
Top Products
2 Use MULTI-CONTROL to select
BT AUDIO.
3 Press MULTI-CONTROL to turn the
BT AUDIO source on.
# To turn the BTAUDIO source off, press
MULTI-CONTROL again.
Microphone setting
While using hands-free phoning, you can use
either built-in microphone or optional micro-
phone.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 40.
2 Use MULTI-CONTROL to select BT MIC.
3 Press MULTI-CONTROL to select the de-
sired setting.
! BT MIC :INT – when using the built-in mi-
crophone
! BT MIC :EXT – when using the optional mi-
crophone
Entering PIN code for
Bluetooth wireless connection
To connect your cellular phone to this unit via
Bluetooth wireless technology, you need to
enter PIN code on your phone to verify the
connection. The default code is 0000, but you
can change this in this function.
! With some Bluetooth audio players, you
may be required to enter the Bluetooth
audio player PIN code in advance to set
this unit for a connection.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 40.
2 Use MULTI-CONTROL to select
PIN CODE INPUT.
3 Push MULTI-CONTROL up or down to
select a number.
4 Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
5 After inputting PIN code (up to 16 di-
gits), press MULTI-CONTROL.
PIN code can be stored in memory.
When you press MULTI-CONTROL again on
the same display, the PIN code you entered is
stored in this unit.
# Pushing MULTI-CONTROL right in the confir-
mation display returns you to the PIN code input
display, and you can change the PIN code.
Editing device name
You can edit the device name.
The device name is set to PIONEER FLAP BT
as default.
1 Display the initial setting menu.
Refer to Adjusting initial settings on page 40.
2 Use MULTI-CONTROL to select
EDIT DEVICE NAME.
3 Press DISP to select the desired charac-
ter type.
Press DISP repeatedly to switch between the
following character types:
Alphabet—Numbers
4 Push MULTI-CONTROL up or down to
select a letter of the alphabet.
5 Push MULTI-CONTROL left or right to
move the cursor to the previous or next
character position.
6 Move the cursor to the last position by
pushing MULTI-CONTROL right after enter-
ing the device name.
Push MULTI-CONTROL right again to store
the device name in memory temporarily.
# Pressing MULTI-CONTROL can also store the
device name in memory temporarily. In this meth-
od, cursor doesn’t need to be the last position.
Initial Settings
En
43
Section
04
Initial Settings