Filter
Top Products
Introduction of audio
adjustments
1 Press MULTI-CONTROL to display the
main menu.
2 Use MULTI-CONTROL to select AUDIO.
Turn to change the menu option. Press to se-
lect.
3 Turn MULTI-CONTROL to select the
audio function.
Turn MULTI-CONTROL to switch between the
audio functions in the following order.
FADER/BALANCE (balance adjustment)—
PRESET EQUALIZER (equalizer recall)—
EQ SETTING 1 (equalizer adjustment)—
EQ SETTING 2 (equalizer fine adjustment)—
LOUDNESS (loudness)—SW SETTING 1 (sub-
woofer on/off setting)—SW SETTING 2 (sub-
woofer setting)—HIGH PASS FILTER (high
pass filter)—BASS BOOST (bass boost)—
SRC LVADJUST (source level adjustment)
4 Press MULTI-CONTROL to display the
setting mode of each function.
# Push MULTI-CONTROL left to displaythe
function selection menu.
# Push and hold MULTI-CONTROL left to dis-
play the main menu.
5 Adjust the each function.
Notes
! To return to the previous display, press
DISP/BACK/SCRL.
! To return to the main menu, pressand hold
DISP/BACK/SCRL.
! To return to the ordinary display, press
BAND/ESC.
! When the subwoofer controllersetting is
PREOUT:REAR, you cannot switchto
SW SETTING 1 (subwooferon/off setting).
(Refer to page 26.)
! You can select the SW SETTING 2 only when
subwoofer output is turnedon in
SW SETTING 1.
! When selecting FM asthe source, you cannot
switch to SRC LVADJUST.
! If you do not operate functions within about
30 seconds, the displayautomatically returns
to the ordinary display.
Using balance adjustment
You can change the fader/balance setting so
that it can provide the ideal listening environ-
ment in all occupied seats.
1 Use MULTI-CONTROL to select
FADER/BALANCE in the audio function
menu.
2 Press MULTI-CONTROL to display the
setting mode.
3 Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press MULTI-CONTROL repeatedly to switch
between fader and balance.
4 Turn MULTI-CONTROL to adjust speaker
balance.
Front/rear speaker balance can be adjusted
between FAD F15 and FAD R15.
Left/right speaker balance can be adjusted be-
tween BAL L15 and BAL R15.
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
# FAD 0 is theproper settingwhen onlytwo
speakers are used.
# When the rear output setting is
REAR SP:SUB W, adjusting the front/rearspeak-
er balance is not effective. Refer to Setting the
rear outputand subwoofer controller on page
26.
Using the equalizer
The equalizer lets you adjust the equalization
to match the car’s interior acoustic character-
istics as desired.
Audio Adjustments
En
22
Section
03