Filter
Top Products
1 Use MULTI-CONTROL to select
SW CONTROL in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return tothe pre-
vious display.
3 Use MULTI-CONTROL to select the de-
sired setting.
Press to switch the segment you wish to set
between left and right. Turn to change the set-
ting of each segment.
Left segment Right segment
REAR SP
(rear speaker setting)
FULL (full-range speaker)
SUB W (subwoofer)
PREOUT
(RCA output setting)
SUB W (subwoofer)
REAR (full-range speaker)
# When you select REAR SP:SUB W, you can
not set PREOUT(RCA output setting).
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer toUsing subwoofer output on page
24).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speakerlead outputs and RCA rear
output are switchedsimultaneously in this
setting.
Switching the ever scroll
When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1 Use MULTI-CONTROL to select
EVER SCROLL in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn the ever
scroll on.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.
Activating the BT AUDIO source
You need to activate the BTAUDIO source in
order to use a Bluetooth audio player.
! You can only operate this function when
Bluetooth adapter (e.g. CD-BTB200) is con-
nected to this unit.
1 Use MULTI-CONTROL to select
BTAUDIO in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2 Press MULTI-CONTROL to turn the
BTAUDIO source on.
# To turn the BTAUDIO source off, press
MULTI-CONTROL again.
Entering PIN code for
Bluetooth wireless connection
To connect your cellular phone or audio player
to this unit via Bluetooth wireless technology,
you need to enter PIN code on your phone or
audio player to verify the connection. The de-
fault code is 0000, but you can change this in
this function.
! You can only operate this function when
Bluetooth adapter (e.g. CD-BTB200) is con-
nected to this unit.
! With some Bluetooth audio players, you
may be required to enter the Bluetooth
audio player PIN code in advance to set
this unit for a connection.
Initial Settings
En
27
English
Section
04