Filter
Top Products
Listening to the radio
1
2
34
5
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
Important
If you are using thisunit in North, Central or
South America, reset theAM tuning step (see
Setting the AM tuningstep on page 32).
1 Stereo (ST) indicator
Shows that the frequency selected is being
broadcast in stereo.
2 LOC indicator
Shows when local seek tuning is on.
3 Band indicator
Shows which band the radio is tuned to, AM
or FM.
4 Preset number indicator
Shows what preset has been selected.
5 Frequency indicator
Shows to which frequency the tuner is
tuned.
1 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
2 Use VOLUME to adjust the sound level.
Rotate to increase or decrease the volume.
3 Press BAND to select a band.
Press BAND until the desired band is dis-
played, FM1, FM2, FM3 for FM or AM.
4 To perform manual tuning, press c or
d with quick presses.
The frequencies move up or down step by
step.
5 To perform seek tuning, press and hold
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You cancancel seek tuning by pressingeither
c or d witha quick press.
# If you press and holdc or d you can skip
broadcasting stations. Seek tuning startsas soon
as you release thebuttons.
Note
When the frequencyselected is being broadcast
in stereo the stereo(ST) indicator will light.
Tuner
En
10
Section
04
HHHHHHHHHHHHHH