Filter
Top Products
Adjusting initial settings
1
Initial settings lets you perform initial set up of
different settings for this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press FUNCTION and hold until the
clock appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
ClockFM Step (FM tuning step)AM Step
(AM tuning step)Warning (warning tone)
AUX (auxiliary input)Dimmer (dimmer)
Brightness (brightness)REAR SP (rear
output and subwoofer controller)Telephone
(telephone)Motion (motion screen)
Use the following instructions to operate each
particular setting.
# To cancel initial settings,press BAND.
# You canalso cancel initial settings byholding
down FUNCTION untilthe unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press FUNCTION repeatedly until clock ap-
pears in the display.
2 Press c or d to select the segment of
the clock display you wish to set.
Pressing c or d will select one segment of the
clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Press a or b to set the clock.
Pressing a will increase the selected hour or
minute. Pressing b will decrease the selected
hour or minute.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press FUNCTION to select FM Step.
Press FUNCTION repeatedly until FM Step ap-
pears in the display.
2 Press c or d to select the FM tuning
step.
Pressing c or d will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Initial Settings
En
31
English
Section
08
HHHHHHHHHHHHHH