Filter
Top Products
2 Press c or d to adjust the brightness
level.
Each press of c or d increases or decreases
the brightness level. 0 15 is displayed as the
level is increased or decreased.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP :FULL) or subwoofer
(REAR SP :S/W) connection. If you switch the
rear output setting to the REAR SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP :FULL). When rear
output are connected to full range speakers
(when REAR SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controllers (low pass filter,
phase) built-in PREOUT :S/W or the auxiliary
PREOUT:FULL.
1 Press FUNCTION to select REAR SP.
Press FUNCTION repeatedly until REAR SP ap-
pears in the display.
2 Press a or b to switch the rearoutput
setting.
Pressing a or b will switch between
REAR SP :FULL (full-range speaker) and
REAR SP :S/W (subwoofer) and that status
will be displayed.
# When no subwooferis connected to the rear
output, select REARSP :FULL.
# When a subwoofer is connected tothe rear
output, set for subwooferREAR SP :S/W.
# When the rear outputsetting is
REAR SP :S/W, you cannotchange the subwoofer
controller.
3 Press c or d to switch the subwoofer
output or non fading output (full-range
RCA output).
Pressing c or d will switch between
PREOUT:S/W and PREOUT:FULL and that
status will be displayed.
Notes
! Even if you change thissetting, there is no
output unless youturn the non fading output
(refer to Using nonfading output on page 28)
or subwoofer output(refer to Using subwoofer
output on page 28)in the audio menu on.
! If you change thesubwoofer controller, sub-
woofer output and nonfading output in the
audio menu return tothe factory settings.
! Both rear speaker leadsoutput and RCA rear
output are switched simultaneously in this
setting.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
! The sound is turned off, MUTE or ATT is
displayed and no audio adjustment is pos-
sible.
! Operation returns to normal when the
phone connection is ended.
1 Press FUNCTION to select Telephone.
Press FUNCTION repeatedly until Telephone
appears in the display.
Initial Settings
En
33
English
Section
08
HHHHHHHHHHHHHH