Filter
Top Products
1 Press AUDIO and hold until FRONT ap-
pears in the display.
2 Press c or d to select the speaker to be
adjusted.
Each press of c or d selects the speaker in
the following order:
FRONT (front speakers)CENT (center speak-
er)REAR (rear speakers)SUB.W (subwoo-
fer)PHASE (subwoofer setting)
# You can switch to PHASE only when the sub-
woofer has been set to ON.
3 Press a or b to select the correct size
for the selected speaker.
Each press of a or b selects the size in the fol-
lowing order:
SML (small)LRG (large)OFF (off)
# You cannot select OFF, when FRONT (front
speakers) have been selected.
# You can select ON or OFF, when SUB.W (sub-
woofer) has been selected.
# You can switch REV (reverse phase) or NOR
(normal phase), when PHASE (subwoofer setting)
has been selected.
4 Press BAND/ESC to return to the play-
back display.
Correcting the subwoofers phase
If trying to boost the bass output of the sub-
woofer doesnt do much or rather makes you
feel that the bass gets more murky, this may
indicate that the subwoofers output and bass
content you hear over other speakers cancel
each other out. To remove this problem, try
changing the phase setting for the subwoofer.
1 Press AUDIO and hold until FRONT ap-
pears in the display.
2 Press c or d to select the subwoofer.
Each press of c or d selects the speaker in
the following order:
FRONT (front speakers)CENT (center speak-
er)REAR (rear speakers)SUB.W (subwoo-
fer)PHASE (subwoofer setting)
3 Press a to turn the subwoofer output
on.
4 Press d to select PHASE (subwoofer
setting).
5 Press a or b to select the subwoofer
output phase.
Press a to select NOR (normal phase). Press
b to select REV (reverse phase).
6 Press BAND/ESC to return to the play-
back display.
Note
When playing a 2-channel mono source with Pro
Logic B turned on, there may be occasions when
the following will occur:
! No audio is outputted if the center speaker
setting is SML or LRG and no center speaker
is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SML or LRG.
Selecting a cross-over
frequency
If DVH-P7050, DVH-P5050MP or AVH-P6550DVD
is connected to this unit, operation is slightly
different.
Digital Signal Processor
En
11
English
Section
03