Filter
Top Products
1 Press AUDIO and hold until FRONT ap-
pears in the display, then press AUDIO to
select T TONE.
After FRONT is displayed, press AUDIO until
T TONE appears in the display.
2 Press d to start the test tone output.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRT-L (front speaker left)CENT (center
speaker)FRT-R (front speaker right)RER-R
(rear speaker right)RER-L (rear speaker left)
SUB.W (subwoofer)
# Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
# The settings do not appear for speakers
whose size is set OFF.
3 Press a or b to adjust the speaker out-
put level.
Each press of a or b increases or decreases
the speaker output level. +10 10 is dis-
played as the level is increased or decreased.
# The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Press c to stop the test tone output.
5 Press BAND/ESC to return to the play-
back display.
Notes
! If needed, select speakers and adjust their ab-
solute output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at FRT-L. Both provide the same re-
sults.
Using the time alignment
The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
Selecting the time alignment
adjustment mode
This function cannot be operated when DVH-
P7050, DVH-P5050MP or AVH-P6550DVD is con-
nected to this unit.
You can select the time alignment adjustment
mode.
1 Press AUDIO repeatedly until INITIAL
appears in the display.
# You cannot select INITIAL when neither F/L
nor F/R is selected in POSI.
2 Press c or d to select the time align-
ment.
! INITIAL Initial time alignment (factory set-
ting)
! CUSTOM Adjusted time alignment that
you can create for yourself
! AUTO TA Time alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on the
next page.)
! OFF Turn the time alignment off
# To turn time alignment off, select TA :OFF.
# You cannot select AUTO TA if auto TA and EQ
has not been carried out.
# You cannot select ADJUSTMENT when
neither F/L nor F/R is selected in POSI.
3 Press BAND/ESC to cancel the time
alignment mode.
Adjusting the time alignment
You can adjust the distance between each
speaker and the selected position.
Digital Signal Processor
En
13
English
Section
03