Filter
Top Products
Getting started04
28
En
3 Press ENTER.
4 Use the
/
(cursor up/down) buttons
to select a room type then press ENTER.
Choose one of the following depending on your
room size:
•
S
– Smaller than average room
•
M
– Average room
•
L
– Larger than average room
5 Use the
/
(cursor up/down) buttons
to select a seating position setting, then
press ENTER.
Choose one of the following depending on
where your main listening position is:
•
Fwd
– If you are nearer to the front
speakers than the surround speakers
•
Mid
– If you are equal distance from the
front and surround speakers
•
Back
– If you are nearer to the surround
speakers than the front speakers
• The Room Setup automatically sets up
channel levels and channel delay. If you
have already set the channel levels
manually (see
Setting the channel levels
on
page 60), you will see
Room Set?
in the
display when you first press the
ROOM
SETUP
button. If you continue, the previous
settings will be overwritten.
Setting up the remote to
control your TV
You can set up the supplied remote to control
your TV using the
TV CONTROL
buttons.
1 Switch on your TV.
2 Find the name of the manufacturer of
your TV in the Preset Code List on page 79.
Next to each manufacturer is one or more
three digit codes. These tell the remote what
kind of TV you have.
If the name of the manufacturer of your TV
does not appear in the table, you won’t be able
to set up this remote to control your TV. Note
that there are also cases where the preset
codes listed for a manufacturer in the table
may not work for your TV.
3 Point the remote at your TV, hold down
the CLEAR button, then enter the three
digit code for your TV.
The remote transmits an on/off signal to the TV.
If you’ve entered the correct code, your TV
should switch off.
If your TV doesn’t turn off, repeat the procedure
using the next code in the list until your TV
switches off successfully. Once set, you can
then use the individual TV controls shown
below.
• The default setting is for a Pioneer TV.
Button
What it does
Switches your TV on or into
standby.
CHANNEL +/–
Changes the TV channel.
VOLUME +/–
Adjusts the volume.
INPUT
Switches the TV’s input
between the built in TV tuner
and an external video source.
TV CONTROL
CHANNELINPUT VOLUME
XV-HTD340.book 28 ページ ２００３年１２月２７日 土曜日 午前１０時３０分