Pioneer S-HTD340 Car Speaker User Manual


 
Surround sound and other settings
09
59
En
Dynamic Range Control
Specifies the amount of dynamic range
adjustment to Dolby Digital or DTS
soundtracks:
DRC Off
– No dynamic range adjustment
(use when listening at higher volume)
DRC Mid.
– Mid setting
DRC High
– Dynamic range is reduced
(loud sounds are reduced in volume while
quieter sounds are increased)
This setting works only with Dolby Digital
and some DTS soundtracks. For other
sources you can create a similar effect
using the Midnight mode (see
Using Quiet
and Midnight listening modes
on page 41).
Dual mono setting
Specifies how dual mono encoded Dolby
Digital or DTS soundtracks should be played.
You can also use this setting to switch the
audio channel on DVD-RW discs recorded with
two separate soundtracks.
L-Ch1 R-Ch2
– Both channels are played
through the front speakers
Ch1 Mono
– Only channel 1 is played
Ch2 Mono
– Only channel 2 is played
On the
Ch1 Mono
and
Ch2 Mono
settings
the sound comes only from the center
speaker (or from the front speakers if
listening in
STEREO
mode).
This setting works only with dual mono
encoded Dolby Digital or DTS soundtracks.
See the disc packaging for channel
information.
LFE attenuator setting
Dolby Digital and DTS audio sources include
ultra-low bass tones. Set the LFE attenuator as
needed to prevent the ultra-low bass from
distorting the sound.
LFE ATT 0
– The LFE channel is played with
no attenuation
LFE ATT 10
– LFE channel is attenuated by
10dB
LFE Off
– LFE channel is not played
SR+ control options for Pioneer
plasma displays
Make the following settings if you have
connected a Pioneer plasma display to this
unit using an SR+ cable (not supplied).
Note that in the function settings below, the
number of video inputs may change depending
on your display. See also
Using this unit with a
Pioneer plasma display
on page 16.
Control mode setting
SR+ Off
– Switches SR+ off (this unit and
the plasma display work independently)
SR+ On
– Switches SR+ on (this unit
sends control signals to the plasma
display)
The following settings are only available if the
Control mode setting (above) is switched on.
Volume control setting
Vol C.Off
– This unit does not control the
volume of the plasma display
Vol C.On
– When this unit is switched to
an input that used the plasma display
(DVD, for example), the volume on the
plasma display is muted so only sound
from this unit is heard.
XV-HTD340.book 59 ページ 2003年12月27日 土曜日 午前10時30分