Filter
Top Products
Getting started
04
17
En
English
Chapter 4
Getting started
System demo setting
Switches the automatic demo feature on or off (this
starts when you plug in for the first time).
1Switch the system into standby.
2 Press
SETUP
.
3 Use the
/
(cursor left/right) buttons to select
DEMO from the menu, then press
ENTER
.
4 Use the
/
(cursor up/down) buttons to select a
setting, then press
ENTER
.
Select from:
•
DEMO ON
– Switches the demo display on.
•
DEMO OFF
– Switches the demo display off and the
system into standby.
Using the Auto MCACC setup for
optimal surround sound
The Multichannel Acoustic Calibration (MCACC) system
measures the acoustic characteristics of your listening
area, taking into account ambient noise, and testing for
channel delay and channel level. After you have set up
the microphone provided, the system uses the
information from a series of test tones to optimize the
speaker settings and equalization (Acoustic Calibration
EQ) for your particular room.
1
Important
• The test tones used for Auto MCACC setup are loud;
however, do not turn the volume down during setup
as this may result in a sub-optimal setup.
• Make sure the microphone and speakers are not
moved during the MCACC setup.
1 Connect the microphone to the MCACC SETUP MIC
jack on the rear panel.
2 Place the microphone at your normal listening
position.
Place the mic horizontally about ear level at your normal
listening position using a table or chair.
Make sure there are no obstacles between the speakers
and the microphone.
TUNE
TUNE
SOUND
SETUP
TEST
TONE
ST
ST
SOUND
RETRIEVER
MCACCADVANCEDSURROUND
SLEEP
SR
ENTER
ENTER
CLEAR
Note
1 You only need to use the Auto MCACC setup once (unless you change the placement of your speakers or your room layout).
VOLUME
STANDBY/ON
DVD DTV
PC/GAME
AUX
MUTE
TUNER
TUNE
TUNE
SOUND
SETUP
TEST
TONE
ST
ST
CHANNEL
SOUND
RETRIEVER
MCACCADVANCEDSURROUND
VOLUME
SR
ENTER
SPEAKERS
SUB WOOFER
CENTER
SURROUND
DIGITAL
AUDIO INPUT
ANTENNA
FM
UNBAL
AM
LOOP ANTENNA75Ω
RL
R
L
FRONT
RL
CONTROL IN
MCACC
SETUP MIC
CONTROL
OUT
SYSTEM CONNECTOR
USE ONLY WITH DISPLAY UNIT.
SEE INSTRUCTION MANUAL.
AC IN
ANALOG
DTV
(OPTICAL)
DVD
(COAXIAL)
AUX
PC/GAME
(OPTICAL)
SX-SW260_KU.book Page17 Wednesday, March29,2006 2:43PM