Filter
Top Products
14
TO BEGIN PLAYBACK
Before turning on the power
Make sure that the input terminals and output terminals are securely connected.
Playback
Turn the volume knob of the Pre-Amplifier to its lowest setting.1.
Turn the Pre-Amplifier’s power on.2.
Turn the TAD-M600’s power on.3.
The power indicator will light red for eight seconds. The light will turn yellow once the TAD-M600 is ready to operate.
Use the Pre-Amplifier’s volume knob to adjust the volume.
To turn off the unit after use, first turn the volume knob of the Pre-Amplifier to its lowest setting, then turn off both the 4.
Pre-Amplifier and the TAD-M600.
Protection circuit
The TAD-M600 is provided with a built-in automatic protection circuit to prevent electrical damage to the amplifier and
speakers. When the protection circuit operates, the power indicator will light red, and no sound will be produced from the
speakers. The protection circuit may operate in the following circumstances:
When power is first turned ON
'
In order to silence potential noise during startup, the muting circuit operates for eight seconds; the indicator lights red
during this time.
In event of malfunction
'
In the event of a short-circuit between speaker terminals, excessive load, or abnormal heat generation, the protection
circuit will operate and the indicator will light red. The protection circuit is of the auto reset type. In the event the protection
circuit operates due to a malfunction, turn off the power, eliminate the source of the malfunction, and turn the power on
again.