Pioneer X-EM21V Car Video System User Manual


 
Additional information 08
27
En
English
Français Deutsch
Italiano
Nederlands
Español
Cautions on use
When moving this unit
When moving this unit, be sure to first check that there is no
disc loaded and disconnect the iPod/iPhone. Then press
STANDBY/ON, wait until [GOOD BYE] disappears on
main display to turn off, and then unplug the power cord.
Damage may occur if the unit is transported or moved with a
disc inserted, or when another device is connected to the
iPod/iPhone connector port, USB terminal, or AUX IN mini-
plug jack.
Place of installation
Choose a stable place near the TV or stereo system being
used with this unit.
Do not place this unit on top of a TV or color monitor.
Also, install it away from cassette decks and other
devices easily affected by magnetic forces.
Avoid the following locations:
Places exposed to direct sunlight
Humid or poorly ventilated places
•Extremely hot places
Places exposed to vibrations
Places in which there is much dust or cigarette smoke
Places exposed to soot, steam, or heat (kitchens, etc.)
Do not place objects on this unit
Do not place any objects on top of this unit.
Do not obstruct the ventilation holes.
Do not use this unit on shaggy rugs, beds, sofas, etc., or
wrapped in cloth, etc. Doing so will prevent the heat from
dispersing, leading to damage.
Do not expose to heat.
Do not place this unit on top of an amplifier or other
components that generate heat. When rack mounting it, to
avoid the heat given off by the amplifier or other audio
components, place it on a shelf below the amplifier.
Turn off the power of this unit when not using it.
Depending on signal conditions, striped patterns may
appear on a TV screen and noise may enter the sound of
radio broadcasts when the power of this unit is on. If this
happens, turn off the power of this unit.
Cleaning the product
Unplug the power cord from the power outlet when
cleaning this unit.
Clean this unit using a soft cloth. For tough dirt, apply
some neutral detergent diluted in 5 to 6 parts water to a
soft cloth, wring out thoroughly, wipe off the dirt, and
then wipe again with a soft, dry cloth.
Alcohol, thinner, benzene, insecticides, etc., could
cause the print or paint to peel off. Also, leaving rubber
or vinyl products in contact with this unit for long periods
of time could mar the cabinet.
When using chemical-impregnated wipes, etc., read the
cautions included with the wipes carefully.
Cleaning the lens
The lens of this unit should not become dirty in normal
use, but if for some reason it should malfunction due to
dust or dirt, consult your nearest Pioneer authorized
service center. Although lens cleaners for players are
commercially available, we advise against using them
since some may damage the lens.
Handling discs
Storing
Always place discs in their cases and store them
vertically, avoiding hot, humid places, places exposed to
direct sunlight and extremely cold places.
Be sure to read the cautions included with the disc.
Cleaning discs
Discs may not play if there are fingerprints or dust on
them. In this case, use a cleaning cloth, etc., to gently
wipe the disc from the inside towards the outside. Do not
use dirty cleaning cloths.
Do not use benzene, thinner or other volatile chemicals.
Also, do not use record spray or antistatic agents.
For tough dirt, apply some water to a soft cloth, wring out
thoroughly, wipe off the dirt, and then wipe off the
moisture with a dry cloth.
Do not use damaged (cracked or warped) discs.
Do not let the signal surface of discs get scratched or
dirty.
Do not attach pieces of paper or stickers to discs. Doing
so could warp discs, making it impossible to play them.
Also, note that rental discs often have labels attached to
them, and the glue of the label may have oozed out.
Check that there is no glue around the edges of such
labels before using rented discs.
X-EM21V_SYXE8_En.book Page 27 Tuesday, July 31, 2012 9:43 AM