Filter
Top Products
6
13. Measure 7” from rear A/C control opening
toward the rear of vehicle. Using a razor knife,
carefully cut an opening in the headliner that is
6” wide x 8 3/4” long. Make sure that the 6”
width is centered in the vehicle. Caution: Before
cutting headliner material, check for wiring
or other componentry above headliner. Cut
only where indicated. See Figure 10.
14. Insert the 6” x 14” piece of plywood through
opening and rotate 90 degrees. See Figure 10.
II. PREPARATION OF CONSOLE FOR INSTALLATION
15. Install front light fixture and secure using (3) three
# 6 x 1/2” screws. Make sure fixture is centered.
See Figure 11.
16. Install trim ring around light.
17. Install rear light fixture and secure using (1) one
# 6 x 1/2” screw in the center hole only. Make sure
fixture is centered. Predrill the remaining (2) two
holes using a 3/32” drill bit.
18. Install front A/C controls original manner. Secure
using four (4) # 6 x 3/8” screws. See Figure 11.
III. INSTALLATION OF CONSOLE
NOTE: Additional assistance in mounting the overhead console in vehicle is advised
to prevent damage to console or components.
FIGURE 10
FIGURE 11