Filter
Top Products
2
Preparing New Discs with Rough Spots
A new disc may have rough edges on its
inside and outside edges. If a disc with
rough edges is used, the proper setting
will not be performed and the player will
not play the disc. Therefore, remove the
rough edges in advance by using a
ballpoint pen or pencil as shown on the
below. To remove the rough edges, press
the side of the pen or pencil against the
inside and outside edges of the disc.
Label sideup
Do nottouch
the underside
of thedisc
Do notbend
Wipe thedisc fromcenter
toward the outside edge
Rough spotson
outside edge
Ball pointpen
or pencil
Rough spotson
inside edge
Notes:
- Choose the mounting location where the unit
will not interfere with the normal driving
function of the driver.
- Before finally installing the unit, connect the
wiring temporarily and make sure it is all
connected up properly and the unit and the
system work properly.
- Use only the parts included with the unit to
ensure proper installation. The use of
unauthorized parts can cause malfunctions.
- Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
- Install the unit where it does not get in the
driver's way and cannot injure the passenger if
there is a sudden stop, like an emergency
stop.
- If installation angel exceeds 30°from
horizontal, the unit might not give its optimum
performance
- Avoid installing the unit where it would
be subject to high temperature, such as
from direct sunlight, or from hot air, from
the heater, or where it would be subject to
dust, dirt or excessive vibration.
Din Front/Rear-Mount
This unit can be properly installed
either from 'Front' (conventional DIN
Front-mount) or 'Rear' (DIN Rear-mount
installation, utilizing threaded screw
holes at the sides of the unit chassis). For
details, refer to the following illustrated
installation methods.
Installation
Take Out Screw Before Installation
Before install the unit, please remove
the two screws.
Takeoutscrews
beforeinstallation
1. DIN Front-Mount(MethodA)
Installing the unit