PYLE Audio PLTDN71 Car Stereo System User Manual


  Open as PDF
of 19
 
4
Beforeinstallingthereceiverpermanently,fititintheapproximateplaceinyourcar,andconnectthe
equipmentaccordingtothespeakersandelectricalconnections.When
yoursystemisoperatedproperly,(preferablywiththe
carenginerunning),followtheinstructions
forpermanentinstallation
ofyoursystem.
1)Adapter
(notsupplied)
2)Bendovertabs
ofhalfsleeve
(supplied)
3)Supportstrap
(supplied)
Halfsleeve
(supplied)
4)Twowrenchesforreleasing
theunit(supplied)
INSTALLTHEUNIT
1)Installhalfsleeve,canbewithor
withoutadapter.Itwillfitbetter
withadapter.
2)Bendoversometabstosecurethe
halfsleeveinsideofdash.
3)Supportstraptobestruttedunder
dash,securethisstriptoavoidskipping
ofdisc.
Insertremovalwrenchintothesmall
gapontherightsideoftheunitandpull
theunitslightlyoutonthesameside,
thenreleasethewrench.Repeatthe
sameactionfortheleftside.Bynow,
youcanremovetheunitandunplug
thewiresconnector.
REMOVETHEUNIT
Installation
 previous next