Filter
Top Products
18
THE FCC WANTS YOU TO KNOW
Your RadioShack DX-396 AM/SW/FM-Stereo PLL Portable Receiver might cause
television or radio interference even when it is operating properly. To determine
whether your receiver is causing the interference, turn it off. If the interference goes
away, your receiver is causing the interference.
To try to eliminate the interference:
• Reorient the DX-396 receiver’s antenna.
• Move your DX-396 receiver away from the television or radio receiver.
• Connect your DX-396 receiver to an outlet that is on a different electrical circuit
from the television or radio receiver.
• Contact your local RadioShack store for assistance.
If you cannot eliminate the interference, the FCC requires that you stop using your re-
ceiver.
Clock flashes.
The receiver had a power inter-
ruption.
Set the time.
Tuning does not stop.
The sensitivity switch is set to
LOCAL
. If the signal is weak,
the receiver does not stop in
LOCAL
.
Set it to
DX
.
Scan tuning does not
stop.
• Receiver is set to memory
scan.
• No incoming signal or
scans in
LOCAL
.
•Press
SCAN
or press the
number key.
• Set it to
DX
.
Problem Probable Cause Solution
20-226.fm Page 18 Tuesday, December 7, 1999 1:48 PM