Filter
Top Products
14
Set Time for LCD Display
You can set the time the LCD displays. To set the time for the status display, follow these steps:
1. Press and hold the SETUP (S) key for 2-3 seconds
until the LCD display shows the Setup Mode? Screen.
2. Release the SETUP (S) key.
3. Press and release the SETUP (S) key repeatedly
until the Clock Setup Screen 1 appears.
4. The cursor under the Hours digits (HH) will be flashing.
Press and release the LEVEL+/UP ARROW or LEVEL-/DOWN
ARROW keys to select the hour. Press and release the ENTER
key once you have reached the correct hour.
Note: To adjust the AM/PM designation, repeatedly
scroll through the hour settings.
5. The cursor under the Minutes digits (MM) now flashes.
Press and release the LEVEL+/UP ARROW or LEVEL-/DOWN
ARROW keys to select the minutes. Press and release the
ENTER key once you have reached the correct minute setting.
The LCD display shows the Success Screen, then returns to
the normal time display. The time setting is now complete.
VCR/DVD Punch-through
Record Key
Additional Features
Your RCU807 punches through the six transport keys (REVERSE, PLAY, FORWARD, RECORD,
STOP and PAUSE) to VCR or DVD Mode, whichever was used most recently. Punch-through to
VCR or DVD transport keys is only allowed for TV, VCR, DVD and CABLE Modes. The SAT and
CD/AUDIO transport keys are dedicated to their programmed modes.
The LCD shows component changes for the VCR or DVD Punch-through keys if they are pressed
in other modes (e.g., If you are in CABLE Mode and you press and release PLAY, either VCR or
DVD is displayed in the LCD).
In the VCR and AUDIO/CD Modes (including Punch-through), the RECORD key must be pressed
twice before the command is sent. This is also true if a VCR component is programmed under any
other mode. The exceptions are for TV, DVD, CABLE and SAT codes, where the RECORD key
transmits the command after only a single RECORD keypress.
RCU807US_IB_REVB 9/26/03 10:18 Page 14