Filter
Top Products
9
Learning Commands
Now you’re ready to have your RCU807 learn the commands from your existing remote(s).
All Learned keys are saved automatically. Remember, only one original remote can be stored
under any one mode.
Codes from the Code Lists include basic functionality for each component they control. Once you
have programmed in the code for your specific component, you can customize the RCU807 to
include certain functions from your original remote(s) that were not embedded in the preset code.
Your RCU807 has the ability to learn and store commands from your original remote(s) under
the mode(s) of your choice. The RCU807 can store more than 30 key commands for each original
remote. Only one original remote can be learned under any one mode (i.e., the RCU807 can learn
the commands for one TV remote, one VCR remote, one DVD remote, etc.).
Code Learning
1. Gather all the remotes that you want to learn and have
them all lined up on a flat surface before going into the
Learn IR Mode.
2. Place the first original remote in the Learning position.
Point the top of the original remote at the base of the RCU807
so the IR LED on the original remote is in line with the
RCU807 Learn sensor, located at the bottom of the remote.
The remotes should be positioned 2-3 inches apart.
3. Press and hold the SETUP (S) key for 2-3 seconds
until the LCD display shows the Setup Mode? Screen.
4. Release the SETUP (S) key.
5. Press and release the SETUP (S) key repeatedly
until the LCD display shows the Learn Mode? Screen.
6. Press and release the desired component key (TV, VCR,
SAT•CBL, AUX1, etc.). The Key? Screen is displayed.
7. Press and release the key on the RCU807 that you wish to
use to store the Learned commands. The Learn Screen appears.
Note: You cannot learn any commands under the
MACRO (M), SETUP (S), INPUT or any component keys.
8. Press and hold the original remote key you want to transfer
to the RCU807 until the Success Screen appears in the display.
This process can take 2-3 seconds to complete.
9. Release the original remote key. If there is a problem during
the Learning process, the LCD displays the Learn Error
Screen for three seconds but still remains in the Learning
Setup Mode. If this occurs, try adjusting the distance between
the remotes slightly and repeat from step 7.
10. Repeat steps 7-9 for other keys to be learned.
11. When all the original remote commands have been learned,
press and release the SETUP (S) key. The display returns to
the normal time display. At this point, you can learn other
keys under another component key by repeating steps 3-9.
The Learning process is now complete.
RCU807US_IB_REVB 9/26/03 10:18 Page 9