6901-100189 <01>
9: Calibrate the Arm
Calibrate Arm to the Monitor
NOTE: LA112 must be calibrated to the TV to avoid hitting the wall.
Reset the LA112 Home Position
1. Turn the control box power switch to “Off”.
2. While holding down the “Set” button, turn the control box power switch back on and continue to hold Set until “Ct” appears in
the LED display.
3. Stand away from the LA112 as it calibrates. LA112 will move back to the home position against the wall when calibration is
complete.
4. If your TV is not parallel with the wall, proceed to the next section, “Reset the LA112 to Home Position”.
1. Move the X-arm to its home position against the wall by pressing the “SEL-IN/OUT” button on the remote control.
2. Insert the pointer into the control box Selector hole and press the “SET” button until the display reads “HP”.
3. Adjust the X-arm to the desired home position using the arrow keys on the remote control.
4. Press and hold the control box “Set” button for three seconds. Now the X-arm will move to the new home position each time
the “SEL-IN/OUT” button on the remote control is pushed.
Adjust Monitor Position
1. Turn the control box power switch to “On”.
2. Press the “X-arm” and the the “Power” keys on the remote control.
3. If the TV width code is not displayed on the control box, press “POWER” on the remote. Then press “SEL-IN/OUT” once to
extend the TV out from the wall. There is no need to hold down the button. Pressing any of the arrow buttons while LA112 is
moving the TV will stop it.
4. Use the remote control arrow keys to move the TV in the desired direction. To stop movement, press any of the arrow keys or
the “SEL-IN/OUT” key.
Avoid property damage and personal injury. Set the correct width for your TV before using the LA112. See the “Setting
LA112 TV Width” section above to set the correct width for your TV. While the LA112 is in motion keep people and objects
away from it and do not leave it unattended.
CAUTION