Filter
Top Products
17
About iPod software version
The iPod software versions that
can be used with this unit are as
follows (operations verified as of
August 2008):
iPod (5th generation) ver: 1.3
iPod classic ver: 2.0
iPod nano (1st generation) ver: 1.3.1
iPod nano (2nd generation) ver: 1.1.3
iPod nano (3rd generation) ver: 1.1.2
iPod nano (4th generation) ver: 1.0.0
iPod touch ver: 2.0
iPhone 3G ver: 2.0
* Please note that no guarantee applies to iPod
operations and future updated versions of iPod
software.
Connecting the iPod
Connect the USB connector.
Connect the iPod as indicated in
the figure below using an optional
cable.
To the vehicle's
USB connector
*2
*1
USB port
iPod with Dock connector port
Dock connector 1 ft. 6 in. (45 cm)
When connecting the iPod, remove
a headphone cable from the iPod.
*1 Use an optional car audio cable.
*2 Connection location differs depending on
the vehicle.
Vehicle type Connection location
xB Connect to the USB connector
near the parking brake.
xD Connect to the USB connector
near the cup holder.
As soon as the iPod is connected, its
power is automatically turned on.
While the iPod is connected to this
unit, SCION (or (check mark)) is
displayed on the iPod.
When the ignition switch is set
to ACC or ON, the iPod's battery
is charged while the iPod is
connected to this unit.
While the iPod is connected to
this unit, the iPod itself cannot be
turned on or off.
The iPod connected to this unit
is turned off about two minutes
after the ignition switch is set to
OFF.
NOTICE
To resolve most problems
when using your iPod with
the Scion Audio system,
disconnect your iPod from the
vehicle iPod connection and
reset it.
For instructions on how to
reset your iPod, refer to your
iPod Owner’s Manual.
•
•
•