Filter
Top Products
ENFORCER SK-910RC4Q Central Receiver
SECO-LARM U.S.A., Inc. 3
Front:
1. Mount in a convenient location where alert tones and LED indicators will be audible/visible.
2. Do not install in a location surrounded by metal as RF signals may be blocked, decreasing range.
3. Do not install in a location exposed to weather, moisture or high humidity.
To open the housing:
1. Remove the antenna by unscrewing the antenna base counterclockwise.
2. Remove the bottom cover starting from point 1 shown in the diagram. Follow with points 2 and 3.
NOTE: Applying outward pressure on the clip points will help release the bottom cover.
3. Before attempting to release point 4, gently slide the bottom cover down and left to bring the
programming buttons out of their holes in the housing.
Installation Notes:
Overview:
4. Disconnect the speaker plug from the PCB to avoid damage
while working with the cover off.
5. When replacing the bottom cover, ensure the speaker wires are
not caught between the speaker and the PCB. Check that buttons
and knobs are properly inserted in their openings in the housing.
NOTE: Buttons and knobs are connected directly to the PCB.
Be gentle to avoid damaging delicate electronics. Do not
force the cover on or off if resistance is felt.
Antenna
Speaker
Status LEDs
Volume
adjustment knob
Bottom:
Top:
To antenna
Timer switches
Mode button
Programming buttons
Power Input
(12VDC)
Main relay outputs
Auxiliary relay output (12VDC)
Clip Points