Filter
Top Products
ENFORCER SK-910RC4Q Central Receiver
8 SECO-LARM U.S.A., Inc.
Troubleshooting:
WARRANTY This SECO-LARM product is warranted against defects in material and workmanship while used
in normal service for a period of one (1) year from the date of sale to the original consumer customer.
SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned,
transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused by or attributed to acts of
God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty
installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as
a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM, and the
purchaser’s exclusive remedy, shall be limited to replacement or repair only, at SECO-LARM’s option. In no
event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damages of any kind to the purchaser or anyone else.
NOTICE: The information and specifications printed in this manual are current at the time of publication.
However, the SECO-LARM policy is one of continual development and improvement. For this reason,
SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible
for misprints or typographical errors.
Copyright © 2010 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied,
in whole or in part, without the written permission of SECO-LARM.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326 E-mail: sales@seco-larm.com
The SK-910RC4Q will not read a
transmitter it has already learned.
Check that the transmitter is operating within the
receiver’s range.
Check number of transmitters learned. Learning more than
15 will cause the first transmitter learned to be deleted.
Check that there are transmitter codes stored on the
channel by pressing that channel’s programming button
once and counting the flashes.
The SK-910RC4Q is not in the correct
relay output mode.
Programming modes change starting from the current
mode. For example, press the programming button 3 times
to go from Toggle Output to Timed Output. If necessary,
please review Programming Channel Output on page 5.
Also Available from SECO-LARM:
Single-Button Transmitter
SK-919TD1S-UP
LED Strobe Light
SL-1301-BAQ Series
Wired RF Transmitter
SK-919TDWS-BU
Desktop Transmitter
SK-919TP2D-P
Dual Photobeam Sensor
E-960-D90Q
Electric Door Strikes
SK-990AQ
MiSK-910RC4Q_1007.docx
PITSW1
Order Part# 762-508-1%