Filter
Top Products
ENFORCER SK-910RC4Q Central Receiver
4 SECO-LARM U.S.A., Inc.
Display Channel Memory:
1. Press a channel’s programming button once.
2. The number of flashes is the same as the number of transmitters that channel has learned.
Clear Channel Memory:
1. Hold down the channel’s programming button for three seconds.
2. The channel’s red LED will start flashing.
3. After the LED has started flashing, hold down the programming button for three more seconds.
The LED will flash two more times, indicating that all codes learned by that channel have been
cleared.
Alert Tones:
Each channel has a specific alert tone. See the chart on the lower right.
1. Open the housing following the instructions under Installation Notes on page 3 of this manual.
2. Locate the Alert Tones DIP switch marked SW7. Switches marked 1 through 4 determine
whether each channel’s sound will play when the respective channel is triggered.
3. If the switch is in the ON position, the alert tone will play when the channel is triggered.
4. If the switch is in the OFF position, no alert tone will play when the channel is triggered.
5. Adjust the volume using the volume adjustment knob.
Each receiver channel can learn the codes of up to 15 different transmitters. Transmitters are
learned on a first-in, first-out basis. (For example, if 15 transmitter codes have been learned, when
a new transmitter is learned the first of the 15 codes that were learned before will be deleted.)
1. To learn a new transmitter, first press and hold the programming button of the channel to be
programmed for 3 seconds or more. (Programming buttons are found on the top of the unit.)
Note: A pencil or other pointed object may be necessary to press the programming buttons.
2. The channel’s red LED will flash quickly to indicate it is in Learning Mode. DO NOT REPEAT
STEP 1 WHILE THE LED IS FLASHING OR CHANNEL MEMORY WILL BE CLEARED.
3. While the channel LED is flashing, press the button of the transmitter being learned one time.
The channel’s LED will flash once to indicate the transmitter code was successfully learned.
4. If no transmitter is learned within 15 seconds, the receiver will return to standby mode.
5. If the transmitter has been learned already, the channel LED will turn steady ON and the code
will not be learned a second time.
Code Learning a New Transmitter:
Displaying or Clearing a Channel’s Memory:
Alert Tones
Channel 1
Doorbell
Channel 2
Bells
Channel 3
Home Sweet
Home
Channel 4
Alarm
PCB
Alert Tone
DIP switch
(SW7)
Volume
adjustment
knob