Filter
Top Products
E-8
ENGLISH
9
CP-SW1000H
Advanced Feature
Volume control
Main unit operation:
Turn volume knob clockwise to increase the volume and anti-
clockwise to decrease the volume.
Remote control operation:
Press the VOL + button to increase the volume and the VOL – button
to decrease the volume.
Note:
Do not turn the volume knob manually in reverse direction when
operating it by remote control.
Crossover frequency control
Adjust the high frequency cut-off point. Frequencies higher than the
set frequency are removed.
To emphasise the bass, turn this control towards 80 Hz and increase
the volume.
Notes:
Observe the following to avoid malfunction and sound distortion.
Do not set the volume too high on the audio system. The
subwoofer may be damaged.
Before you switch on/off the subwoofer, minimise the volume on
the audio system.
Auto power off
If no signal is detected for 20 minutes during power on, the
subwoofer will automatically go to stand-by mode.
Operating the TV with the remote
control
You can operate SHARP TV with this system’s remote control.
Watching TV
Other operable button
Press the Input Select button to switch the input source. (TV)
Note:
Some models of SHARP TV may not be operable. In this case, use
the remote control supplied with each product.
Point the remote control at the TV.
1 Press the TV POWER button to turn on the TV.
2 Press the CH UP or CH DOWN button to set the
channel.
Pressing the CH UP or CH DOWN button enables TV
channel switching.
3 Press TV VOL + or – button to adjust the TV volume.
TV operation buttons