Filter
Top Products
8
Quick guide
Before turning on the power
*
Standard DIN45325 plug (IEC 169-2) 75 q coaxial cable
AC cord (Product shape varies in some countries)
The AC cord is supplied either with a ferrite core or without a ferrite core. Neither
type causes unnecessary electrical wave emissions or interference.
n
o
*
Place the TV close to the AC outlet,
and keep the power plug within
reach.
Supplying power to the antenna
When an active antenna is used, power must be supplied to the antenna using the following procedures after
connecting the antenna cable to the antenna terminal on the rear of the TV in order to receive terrestrial digital
signals.
Press @ and the “MENU” screen displays.
Press c/d to select “Setup”.
Press a/b to select “Antenna Setup”, and then press ;.
Press a/b to select “Supply Voltage”, and then press ;.
Press c/d to select “On”, and then press ;.
1
2
3
4
5
Mounting the TV on a wall
This TV should be mounted on a wall only with the wall mount bracket available from SHARP (Page 5). The use of other wall
mount brackets may result in an unstable installation and may cause serious injuries.
Mounting the LCD colour TV requires special skills and should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that
results in accident or injury.
You can ask qualified service personnel about using an optional bracket to mount the TV to a wall.
When you mount the TV on a wall, you should attach the supporting post.
When using wall mount bracket AN-37AG5
You can check the centre of the TV screen using the mark engraved on the wall mount bracket when mounting the TV
on the wall.
AN-37AG5
LC-32DH57E: The centre of the TV screen is 24.5 mm above the mark “A” on the wall bracket.
•
•
•
•
LC-32DH57V_GB.indd 8LC-32DH57V_GB.indd 8 2009/04/24 17:38:352009/04/24 17:38:35