Filter
Top Products
11
If your outdoor antenna uses a 75-ohm coaxial cable with a standard
DIN45325 plug (IEC 169-2), plug it into the Antenna In terminal at the
rear of the TV set.
If your outdoor antenna uses a 300-ohm twin-lead flat feeder, connect a
300-ohm to 75-ohm impedance converter and plug it into the Antenna In
terminal at the rear of the TV set.
Connecting to an antenna via a VCR
You can also connect the TV set to the tuner on a VCR using the connection shown below.
• Remove the power cord from the power outlet before connecting the antenna to the TV set.
• When using the RF terminal connection, set the TV to channel zero to make initial adjustments for the VCR.
• Turn off the power on the TV set and the VCR being connected before making the above connections.
• Be sure the cord plugs are fully inserted in the connection terminals.
• See the operation manual of your VCR for connection details.
Connecting to an antenna
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of
the types of connections that are used for coaxial and feeder cables.
Antenna connections
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable) (not supplied)
300-ohm twin-lead
flat feeder
(not supplied)
75-ohm impedance
converter
(not supplied)
TV
Antenna In terminal
VCR
TV
Antenna In
terminal
To antenna in
terminal
To RF out
terminal
03.7.30, 8:59 AMPage 11