Sharp XL-DH350NH Car Stereo System User Manual


 
04/1/28 XL-DH350NH EN.fm
6
Remote control
Caution:
Replace all old batteries with new ones at the same
time.
Do not mix old and new batteries.
Remove the batteries if the unit will not be used for a
long period of time. This will prevent potential damage
due to battery leakage.
Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
Installing the batteries incorrectly may cause the unit to
malfunction.
Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire or
the like.
Notes concerning use:
Replace the batteries if the operating distance is
reduced or if the operation becomes erratic.
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
Keep the remote control away from moisture, heat,
shock, and vibrations.
Check the remote control after checking all the
connections.
Point the remote control directly at the remote sensor on
the unit. The remote control can be used within the range
shown below:
General control
Press the ON/STAND-BY button to turn the power on.
To dim the display brightness, hold down the CLEAR/
DIMMER button on the remote control for 2 seconds or
more.
If you turn off and on the main unit with the volume set to
27 or higher, the volume starts at 16 and fades in to the last
set level.
Turn the volume knob towards VOL +/– (on main unit) or
press VOLUME +/– (on remote control) to increase or
decrease the volume.
When the power is first turned on, the unit will enter the
extra bass mode which emphasises the bass frequencies,
and “X-BASS” will appear. To cancel the extra bass mode,
press the X-BASS button on the remote control.
1
Press the BASS/TREBLE button to select “BASS”.
2
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the bass.
1
Press the BASS/TREBLE button to select “TREBLE”.
2
Within 5 seconds, press the VOLUME (+ or –) button to
adjust the treble.
When the EQUALIZER MODE button is pressed, the
current mode setting will be displayed. To change to a
different mode, press the EQUALIZER MODE button
repeatedly until the desired sound mode appears.
Battery installation
1
Open the battery cover.
2
Insert the supplied batteries according to the direction
indicated in the battery compartment.
When inserting or removing the batteries, push them
towards the (–) battery terminals.
3
Close the cover.
Test of the remote control
Use 2 “AAA” size batteries (UM/SUM-4, R3, HP-
16 or similar). Batteries are not included.
CD
USB
0.2 m - 6 m
(8" - 20' )
Remote sensor
To turn the power on
After use:
Press the ON/STAND-BY button to enter the power
stand-by mode.
Display brightness control
Volume auto fade-in
Volume control
X-Bass control
Bass control
Treble control
Equaliser
CD
USB
POPS
VOCAL
JAZZ
FLAT
GAME
CLASSIC
For rock music.
For pop music.
No equalization.
For classical music.
For jazz.
Vocals are enhanced.
No equalisation.
For game.
For classical music.
For pop music.
Vocals are enhanced.
For jazz.