Filter
Top Products
C
OMMAND
L
INE
I
NTERFACE
4-144
Interface Commands
These commands are used to display or set communication parameters for
an Ethernet port, aggregated link, or VLAN.
Table 4-40 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface
configuration mode
GC 4-145
description Adds a description to an interface configuration IC 4-145
speed-duplex Configures the speed and duplex operation of a
given interface when autonegotiation is disabled
IC 4-146
negotiation Enables autonegotiation of a given interface IC 4-147
capabilities Advertises the capabilities of a given interface
for use in autonegotiation
IC 4-148
flowcontrol Enables flow control on a given interface IC 4-149
shutdown Disables an interface IC 4-150
switchport
broadcast
packet-rate
Configures the broadcast storm control
threshold
IC 4-151
clear counters Clears statistics on an interface PE 4-152
show interfaces
status
Displays status for the specified interface NE,
PE
4-153
show interfaces
counters
Displays statistics for the specified interfaces NE,
PE
4-154
show interfaces
switchport
Displays the administrative and operational
status of an interface
NE,
PE
4-156